Posted By: Kirk Harding
profec A ebc - October 16, 2014 01:07 am UTC
Just want some input on how you set yours up, the Manual says port 1 isn't used but mine came setup like the pic below any ideas?
Posted By: Bryan Lawrence
Re: profec A ebc - October 16, 2014 01:49 am UTC
may I ask how much did you grab that for?
Maybe draw a picture of where all your vac hoses, that would make things a lot easier.
EBCs from Greddy run between 125-150$ used
http://www.supramania.com/forums/showthread.php?2841-Profec-A-install-write-upI have the Profec B, mine doesn't have that port but looks like it's just vac. Even GReddy says not to use it.
http://web.archive.org/web/20030215135958/http://www.greddy.com/Technical/profec_frame.htm
Posted By: Rob Strelecki
Re: profec A ebc - October 16, 2014 02:47 am UTC
Isn't port 1 the boost signal to the controller? Looks like the A has it as part of the solenoid. I have a B and just like in the diagram, port 1 is on the controller and takes the IM signal.
Posted By: Rob Strelecki
Re: profec A ebc - October 16, 2014 04:44 pm UTC
Kirk, the way you have it routed might result in lower boost than what you demand on the controller. Assuming you see higher pressure at the turbo compared to at the IM, boost gauge and what actually enters the motor.