Posted By: Rafal Kuleta
The Adhesive and the Gasket .....+ Port and Polishing ? - August 19, 2002 03:24 pm UTC
1. What kind of adhesive would/could/should i use on the Throttle Body Gasket to hold it in place ?
2. ...Did anyone here do a whole intake job ? (k&n, Thrrottle body boring, aftermarket intake manifold,and port and polishing job on the cylinder heads) Any suggestions ...concerns etc about that ?
3. What would be the benefits of this if a turbo was installed later on ?
2. ...Did anyone here do a whole intake job ? (k&n, Thrrottle body boring, aftermarket intake manifold,and port and polishing job on the cylinder heads) Any suggestions ...concerns etc about that ?
3. What would be the benefits of this if a turbo was installed later on ?