Posted By: Ryan Prokopetz
HELP! Big16g Install not going well.. - September 24, 2016 04:11 am UTC
Hey Guys,
Im at a bit of a loss with the install of my big16g..
So.. Ive got a 98 gst, with a 7 bolt.
Stock turbo died, so I seized the opportunity to upgrade. Stock intercooler was shot too so I picked up a punishment FMIC from Ziggy (long ago)
Finally getting to the install after accumulating parts for two years...Immediately I noticed that the turbo needed to be clocked to line up with the jpipe.. so I did that.. Got everything bolted up EXCEPT THE FRICKN WASTEGATE ACTUATOR! So once I clocked it the spot where it mounted before isn't where it needs to be and if it were, the Jpipe is in the way. Can you guys shed some light? some pics of similar setup?
Heres a complete list of related components im running..
FP intake with recirc
16g turbo
tubular manifold
atmosphere dump 02 housing
Any help would be appreciated.. Did lots of reading but was unable to find specific info on this issue and im sure someone has ran into this that can chime in
thanks in advance
ryan
Im at a bit of a loss with the install of my big16g..
So.. Ive got a 98 gst, with a 7 bolt.
Stock turbo died, so I seized the opportunity to upgrade. Stock intercooler was shot too so I picked up a punishment FMIC from Ziggy (long ago)
Finally getting to the install after accumulating parts for two years...Immediately I noticed that the turbo needed to be clocked to line up with the jpipe.. so I did that.. Got everything bolted up EXCEPT THE FRICKN WASTEGATE ACTUATOR! So once I clocked it the spot where it mounted before isn't where it needs to be and if it were, the Jpipe is in the way. Can you guys shed some light? some pics of similar setup?
Heres a complete list of related components im running..
FP intake with recirc
16g turbo
tubular manifold
atmosphere dump 02 housing
Any help would be appreciated.. Did lots of reading but was unable to find specific info on this issue and im sure someone has ran into this that can chime in
thanks in advance
ryan