Hey guys.

I was wondering if anyone could answer a few questions I have about moddifying my N/T Talon.

I'd like to get the head done on my Talon. While I'm at it I'd also like to do the cams. Now I've heard that when you change the cams, your car may not pass emissions. Is this true?

I was looking at Crane Cams:

Radical street/race profile

Super strong mid and top end

Use cylinder head porting, header with low restriction exhaust

Ported intake w/low restriction air intake system

RPM range 2,000-7,200

Advertised Duration Int/Exh: 250 / 250
Duration @ .050 Int/Exh: 208/208
Lobe Separation: 108
Gross Lift: 374/374

I'm in the works of getting a header and that will be going on next year after I get the head done as well. But when I get the head done I want to do the cams as well.

What do you guys think?

I've also been told that to change the cams, I need to swap my car over to a mass air sensor. I know a 95 Esi is different then 96+ Esi's. I can't remeber what the difference is, but I seem to remeber it being something with the air intake. But I forget exactly what it was. Does anyone know?

Thanks guys.
Brian