I am having trouble finding the proper pin out for the harness that goes to the sensor, If some one is running the zeitronix wideband set up, could you take a look or a pic of the connector that plugs into the o2. To be clear, its the harness from the brain to the sensor. The wires I found on the harness side are
lt blue
white w/ lt blue stripe
Orange
white w/ orange stripe
green
white w/green stripe
brown
white w/ brown stripe
someone please help need the wb to work

Found this:
WIRE COLOR FUNCTION
1 RED Switched power (ex. ignition)
2 WHITE Linear Wideband Analog Output
3 GREEN RPM Input. 0-5V, 0-12V square wave, tach signal, primary (low voltage) side of ignition coil, crank, cam sensor
4 ORANGE Zeitronix Boost (MAP) Sensor Input
5 WHITE/BLUE Warning Output
6 YELLOW Zeitronix Boost Sensor +5V Power.
7 BLACK Power Ground
8 WHITE/BROWN USER 2 Input 0-5V. Programmable for Air Intake, Water, Oil Temperature. Fuel, Boost Pressure
9 PURPLE Programmable Simulated Narrowband O2 Output
10 GREY Throttle Position Sensor
11 BROWN Sensor Ground (Boost Sensor ground reference)
12 BLUE USER1 Input 0-5V
WHITE and BROWN wires are provided to connect the Zt-2 Wideband Controller to your favorite engine management system.

Also said that if you have the model you can go on their website and look up the info on their.

Thanks brian, but I need the pin out for Oxygen Sensor Harness for Zt-2 Model 2009/Earlier, it plugs into the o2 sensor(under the hood) has a 6 pin connector and 8 wires. I will try to find a pic and post it

I also tried to e-mail them, now I get to wait and see how there customer service is lol.