Previous Thread
Next Thread
Print Thread
Rate Thread
Meth Failsafe Setup #439971
May 16, 2015 09:38 pm UTC
May 16, 2015 09:38 pm UTC
Joined: Oct 2010
Posts: 9,968
Caledon, Ontario, Canada
Bryan Lawrence Offline OP
Senior Member, with Far TOO Much Time on Their Hands
Bryan Lawrence  Offline OP
Senior Member, with Far TOO Much Time on Their Hands
***
Joined: Oct 2010
Posts: 9,968
Caledon, Ontario, Canada
So I was PMing with Ghiz the Whiz and discussing what my setup was going to be.
I figure I should post it up here to see what peoples thoughts are.

Car starts
-Pump is on, auto off when hits desired pressure
-Pressure sensor grounds the idle switch (Ghiz's suggestion, which I like!) telling it to use the high octane fuel map
-Punch the gas pedal, at set psi the solenoid that is right before the nozzle opens and sprays the meth

My thoughts here are if there is ever a time that I run out or the line bursts or something like that than the switch won't activate and I will stay with retarded timing and the car will be fine.


"Old Blue" 91 Talon TSi AWD
"Super Enthusiast" 91 Talon TSi AWD
Checkout DSMFAQ.com!
Re: Meth Failsafe Setup [Re: Bryan Lawrence] #439974
May 16, 2015 11:34 pm UTC
May 16, 2015 11:34 pm UTC
Joined: Jun 2012
Posts: 2,669
Toronto, Ontario
Stephan Tanchak Offline
Insane Member
Stephan Tanchak  Offline
Insane Member
*****
Joined: Jun 2012
Posts: 2,669
Toronto, Ontario
I've had my meth line pop off before (old worn line). I replaced it with a new line since, but it felt like it was raining inside the car before, and that was with it injecting at a certain PSI. Had the pump of been running constantly, then it would have soaked me with methanol.


1998 Eclipse GSX Spyder 11.5@124
AWD Talons: 1992, 1993, 1997, 1998

Team Big Turbo

PHP: 2
Re: Meth Failsafe Setup [Re: Bryan Lawrence] #439976
May 17, 2015 01:16 am UTC
May 17, 2015 01:16 am UTC
Joined: Oct 2010
Posts: 9,968
Caledon, Ontario, Canada
Bryan Lawrence Offline OP
Senior Member, with Far TOO Much Time on Their Hands
Bryan Lawrence  Offline OP
Senior Member, with Far TOO Much Time on Their Hands
***
Joined: Oct 2010
Posts: 9,968
Caledon, Ontario, Canada
Yeah that's the other part is I haven't figured out where I will be mounting the pump and resevoir.


"Old Blue" 91 Talon TSi AWD
"Super Enthusiast" 91 Talon TSi AWD
Checkout DSMFAQ.com!

Powered by UBB.threads™ PHP Forum Software 7.6.1.1