Aft License Plate
#442815
August 27, 2015 05:03 pm UTC
August 27, 2015 05:03 pm UTC
|
Joined: Jun 2003
Posts: 500 Oshawa
Steve Rode
OP
Serious Member
|
OP
Serious Member
Joined: Jun 2003
Posts: 500
Oshawa
|
Hey Guys,
Took the Talon to the local car wash and it ripped off my plate.
Now I can't seem to figure out how to put it back on.
It was held there before by two blocks...I guess the screw goes into the block, and the punctured back creates a type of "clip" that holds the plate in.
Is there an easy way to do this?
'93 Tsi AWD AT, 16G Turbo,3" front to back '11 Evolution X, stock
|
|
|
Re: Aft License Plate
[Re: Steve Rode]
#443297
September 10, 2015 10:10 pm UTC
September 10, 2015 10:10 pm UTC
|
Joined: Jun 2003
Posts: 500 Oshawa
Steve Rode
OP
Serious Member
|
OP
Serious Member
Joined: Jun 2003
Posts: 500
Oshawa
|
Just to update everyone:
I found a "Ultimate License Plate" Kit at Canadian Tire for $9.99.
They had some parts that I put in, screwed in the screw and seems pretty good.
On the bad side, my DSM license plate cover was not compatible, so I'm sans aft plate cover.
'93 Tsi AWD AT, 16G Turbo,3" front to back '11 Evolution X, stock
|
|
|
Re: Aft License Plate
[Re: Steve Rode]
#443306
September 11, 2015 01:15 pm UTC
September 11, 2015 01:15 pm UTC
|
Joined: Dec 2000
Posts: 4,398 Ajax, ON
Reza Mirza
Senior Member, with Far TOO Much Time on Their Hands
|
Senior Member, with Far TOO Much Time on Their Hands
Joined: Dec 2000
Posts: 4,398
Ajax, ON
|
Agreed, 1g DSM's are not meant to be taken through those cloth car washes, only touch less. Next time it will be the spoiler!
|
|
|
|
|