Re: Real HKS SSQV BOV $150
[Re: Ziggy Dietrich]
#341516
October 28, 2010 09:02 pm UTC
October 28, 2010 09:02 pm UTC
|
Joined: Sep 1998
Posts: 6,079 Mississauga, Ontario
Jeff Mitchell
Senior Member, with Far TOO Much Time on Their Hands
|
Senior Member, with Far TOO Much Time on Their Hands
Joined: Sep 1998
Posts: 6,079
Mississauga, Ontario
|
Like Dave said, the flange used on a Mazdaspeed is very similar to what DSM guys use to adapt to the 1G BOV flange. The HKS BOV goes in the "cup" of the flange and is secured with a circlip, and then there's two bolts to secure the flange to the IC pipe. If the bolt spacing was the same (maybe a long shot...) you could probably reuse the flange. If not it might be close enough to slot the holes and reuse it anyway.
|
|
|
Re: Real HKS SSQV BOV $150
[Re: Ziggy Dietrich]
#341557
October 29, 2010 12:39 pm UTC
October 29, 2010 12:39 pm UTC
|
Joined: Aug 2007
Posts: 236 woodbridge, ontario
David D'Ambra
OP
Serious Member
|
OP
Serious Member
Joined: Aug 2007
Posts: 236
woodbridge, ontario
|
Like Dave said, the flange used on a Mazdaspeed is very similar to what DSM guys use to adapt to the 1G BOV flange. The HKS BOV goes in the "cup" of the flange and is secured with a circlip, and then there's two bolts to secure the flange to the IC pipe. If the bolt spacing was the same (maybe a long shot...) you could probably reuse the flange. If not it might be close enough to slot the holes and reuse it anyway. Yea thats what I meant. Its just a flange that can be removed with a circlip.Here is a picture so you can see how close they are: http://thumbs.ebaystatic.com/pict/370279771650_0.jpgSo it would probably be best to sell the bov WITHOUT the mounting flange if selling it here, and sell the mounting flange separately on a Mazda board...or sell the whole thing on a Mazda board... I'd rather sell the entire thing together and the buyer can choose to adapt it, remove the flange and sell it, or just throw it out. Up to the buyer
Last edited by David D'Ambra; October 29, 2010 12:46 pm UTC.
|
|
|
Re: Real HKS SSQV BOV $150
[Re: David D'Ambra]
#341561
October 29, 2010 01:27 pm UTC
October 29, 2010 01:27 pm UTC
|
Joined: May 2003
Posts: 7,263 Niagara Falls, Ontario
Ziggy Dietrich
Senior Member, with Far TOO Much Time on Their Hands
|
Senior Member, with Far TOO Much Time on Their Hands
Joined: May 2003
Posts: 7,263
Niagara Falls, Ontario
|
From the pic, I would say if that doesn't fit the 1g flange, it should be EASILY adaptable to fit!
"bluebird" worlds fastest scooter ridden by me "Whitebird" RIP
|
|
|
|
|