Holset turbo with stainless steel bolt on housing. Everything new and never bolted. Also comes with 2 oil flanges($40).
Price: $680

No one wants a fast spooling turbo? This small h1c spool like a 14b and flow 47 lb/min.

I'd like to see some proof of this! Do you have any datalogs supporting that claim?

A 14B is good for about 200 gm/sec or 26.5 lbs/min at 70 degrees F at sea level. So you can see why I find this a little hard to believe. 20lbs/min more airflow, yet the same spool....doesn't quite add up.

There's always alot of hype concerning the Holsets, but not much real-world results.

I wish I had installed this turbo so I can post up some logs for you guys.

On tuners there’s log comparisons between the 54mm h1c vs. the small 16g which the h1c spool a bit faster and flow more.
http://www.dsmtuners.com/forums/tur...et-turbos-part-3-a-14.html#post151442325
I don't know if Holset are hype or not but there's tons of great real-word result and proof with the bigger hx40\35 over on tuners.

I assuming since this is a smaller 50mm version h1c it should spool around the 14b or at least faster than a small 16g.