|
1gb rear bumper support/ Side skirt pieces
#246653
November 06, 2007 04:15 am UTC
November 06, 2007 04:15 am UTC
|
Joined: Jun 2005
Posts: 177 Newmarket
Branden Jones
OP
Regular Member
|
OP
Regular Member
Joined: Jun 2005
Posts: 177
Newmarket
|
Well I realized that when your doing a 1ga to 1gb conversion you need a few more parts then I figured. What I need is the rail that is spot welded to the rear end of the car that the top of the rear bumper bolts to.
I am also looking for the side skirt pieces for both sides preferably in black.
1992 VW Golf GTI 16V - The new project 2004 Jeep TJ - Got Mudd?
|
|
|
Re: 1gb rear bumper support/ Side skirt pieces
[Re: jason harris]
#246795
November 07, 2007 03:36 am UTC
November 07, 2007 03:36 am UTC
|
Joined: Jun 2005
Posts: 177 Newmarket
Branden Jones
OP
Regular Member
|
OP
Regular Member
Joined: Jun 2005
Posts: 177
Newmarket
|
Thanks for the offer, but I made a slight mistake when I posted. what I need is the support rail from a 92-94 Talon. This picture will explain. Between the green lines the 1gb talon rail drops down to make room for the lights.
1992 VW Golf GTI 16V - The new project 2004 Jeep TJ - Got Mudd?
|
|
|
Re: 1gb rear bumper support/ Side skirt pieces
[Re: Brian Fernandez]
#247522
November 14, 2007 12:28 am UTC
November 14, 2007 12:28 am UTC
|
Joined: Jun 2005
Posts: 177 Newmarket
Branden Jones
OP
Regular Member
|
OP
Regular Member
Joined: Jun 2005
Posts: 177
Newmarket
|
As long as it is a 92 Talon . Is the driver side rear quarter where the bumper attaches any good? mine is completly rusted out on the bottem so I need to weld in new metal. I'm not sure if wednesday will work out unless its a bit later like 8:00 or something.
1992 VW Golf GTI 16V - The new project 2004 Jeep TJ - Got Mudd?
|
|
|
|
|
|