Well the 40mm worked out pretty damn good. I'd still go with a 45 if I were to do it again, but really IMO you're fine either way.

I'm 99% done with the install. Only thing I have left to do is clamp (ziptie, clamp, whatever) the brake line somewhere in the middle. I'm not going to do that until I get the tranny and axles back in though. Oh and I suppose bleed them. My brake fluid is ancient (probably stock stuff from 1991 still). So I bought some standard off the shelf new fluid I'll be throwing in.

Also someone mentioned that their spacers weren't perfect. Mine weren't either, but they were damn close. I'm guessing every car might be a hair different so I'm not suprised I had to modify them slightly. On mine the spacers worked perfect for the bottom bolts, and "OK" for the top bolts on both sides. I'm sure they would have worked fine, but I just wanted to make sure I had that caliper as perfectly centered on there as could be. I ended up sanding both top spacers down about 1/32 of an inch (not sure what that is in metric world), which is barely anything. And now I think they are looking damn near perfect. So don't take that as me knocking the kit. Overall I'm pretty happy with the kit, and on something like this no one should be suprised that you may need to shim things to perfectly fit your specific vehicle. Only question I have, which Ziggy can probably answer, is if there is a reason the brackets are made of carbon steel? Aluminum or SS brackets would look a lot nicer and would not rust. I will be powdercoating these this winter when the car is stored to prevent rusting, but just thought I'd ask as I'm not a metal expert.

Also, these 2G lines worked out perfect in my opinion. So might want to consider those if your making a "complete" kit Ziggy. I wanted to add, that I better be getting 50% of all your profits you make on your "complete kit" now for all this info J/K

Here's some pics:

Brake line removed:
http://www.mitsustyle.com/forums/attachment.php?attachmentid=8926&d=1246593644

2G braided brake line installed:
http://www.mitsustyle.com/forums/attachment.php?attachmentid=8927&d=1246593644
http://www.mitsustyle.com/forums/attachment.php?attachmentid=8928&d=1246593674

Inside caliper gap:
http://www.mitsustyle.com/forums/attachment.php?attachmentid=8929&d=1246593674

Oustide caliper gap:
http://www.mitsustyle.com/forums/attachment.php?attachmentid=8930&d=1246593707