Waste gate flapper question - Club DSM Canada

Register Log In Forums General Technical Discussions Waste gate flapper question

Print Thread

Rate Thread

Re: Waste gate flapper question #33631 December 15, 2003 12:10 pm UTC December 15, 2003 12:10 pm UTC
Joined: Jan 2000 Posts: 7,503 Trenton, On, Canada. Ghislain Goudreau Senior Member, with Far TOO Much Time on Their Hands
Ghislain Goudreau Senior Member, with Far TOO Much Time on Their Hands Joined: Jan 2000 Posts: 7,503 Trenton, On, Canada.	It should compleately cover the Hole. The Arm might be bent or something. The Flaper Arm Seems to be the cause of the problem. Is there or can you see any wear in the Casting or in the Axle (for lack of a better term)??? Ghislain. Rouge!!!

Entire Thread
Subject	Posted By	Posted
Waste gate flapper question	Matt Toeppner	December 15, 2003 07:57 am UTC
Re: Waste gate flapper question	Ghislain Goudreau	December 15, 2003 12:10 pm UTC
Re: Waste gate flapper question	Matt Toeppner	December 16, 2003 02:48 am UTC
Re: Waste gate flapper question	Matt Toeppner	December 17, 2003 08:24 pm UTC
Re: Waste gate flapper question	Rob Greer	December 17, 2003 09:23 pm UTC
Re: Waste gate flapper question	Pascal Perreault	December 17, 2003 09:35 pm UTC
Re: Waste gate flapper question	Rob Cauduro	December 17, 2003 10:49 pm UTC

Moderated by Chris Mckee, Jeff Mitchell, Rob Greer, Rob Strelecki, Ryan Laliberte, Steve Kinnaird, Tim Hunt, Vince Amato

Hop To

Powered by UBB.threads™ PHP Forum Software 7.6.1.1