I started by dying the main hatch panel.


I also washed all the other pieces off and let them dry.



Before I put everything back in I wanted to clean up the floors, sadly my small shop vac was at home so I couldn't do the greatest job, before I do the final assembly I'll have to bring it out.




I then put the rear panels in but hit a small snag, the center trunk panel needs some trimming to sit flush with the aluminum floor. The other pieces may need to be trimmed too. I'll fix this at a later date.



I then moved on to pulling my engine and front chassis harnesses from the car. This was actually pretty easy, I labelled everything I knew but some things will need to be researched before any work starts. Once I have everything labelled I can make a plan of attack.


[img]http://img.photobucket.com/albums/v87/G2Rac/96%20Talon%20TSI%20AWD/Wire%20Tuck/102_1647.jpg[/img]

Chassis harness.
[img]http://img.photobucket.com/albums/v87/G2Rac/96%20Talon%20TSI%20AWD/Wire%20Tuck/2011-09-18111201.jpg[/img]

No wiring.
[img]http://img.photobucket.com/albums/v87/G2Rac/96%20Talon%20TSI%20AWD/Wire%20Tuck/2011-09-18111209.jpg[/img]

Finally I got the bumper painted but ran out of time for clear coat, doesn't look half bad for a rattle can job though.
[img]http://img.photobucket.com/albums/v87/G2Rac/96%20Talon%20TSI%20AWD/Apperance/2011-09-18113343.jpg[/img]