So my poor knee is hurting from keeping the gas steady in the dsm...

Anyone got a cruise setup?? I have a non cruise cable to trade if needed.

I can't remember if I still have mine or if I gave mine to Chris to hack up and make a non cruise cable.
I will check and let you know.

I have the 2g setup, if you can retrofit it into a 1g PM me

I got the whole thing but cut the cable going to the pedal cause the pedal was seized... Other then that I got it all.

I'd like to see a complete unit. Not sure what I would do about a cut cable?

LMK Bryan

Sorry Mike, no luck.

I cut my cable for mine so you can definitely do it.
Use something like this, I have one and mine has been good for almost a year now.
http://www.autozone.com/autozone/accessories/Miscellaneous-Repair-Parts/Cable-Stop-Clamp/_/N-25g8

Sorry to hijack...but here's my set up

I think we still have the cruise cables from a 91 in the pile of parts from the car... We are planning on sorting them on Saturday and I could put them aside... I would trade for the non-cruise cable since were going to buy one anyways...

Derek.

Sounds good Derek, Let me know

Ok, went to both shops and grabbed what I have...

I have the cable with the 2 cables in, the other other cable to the vacuum piece and the part that goes to the firewall and all 3 cables plug into and what I assume is the actuator under it...

I have some pictures which I will post after dinner and I get them off my phone.. I should also have the module in the wire harness as well which is sitting on my workbench at home...

D.

Attached is the picture of the parts... if this is cool me know...



D.

Looks good

I will go pull my non cruise cable and let you know when I am up your way next?

That sounds perfect... PM me and we can arrange the details...