Its been since mothers day since I seen the car.

Today was seat day. Determined to get one properly installed.

History:

1- RSX seat WILL sit to the side 3" from center and too HIGH with any sort of after market bracket

2- DSM floor not flat,

So I decided to change the floor. I drilled out all the spot welds for the rear re-bar. Then I bashed it out.







Then I bashed this area down as close to the floor as possible, and bashed it in towards the center console as good as I could without tearing the sheet metal.



No I can use the DSM brackets, which I cut off the oem rails, and bolt them to new locations on the floor which will better center the seat, and give me a close to OEM height.



The brackets actually sit BEHIND the OEM floor studs by about 3" now and more than an inch and a half lower.



I bolted the DSM brackets to the RSX rails like this







Floor ready for drilling after I mark my spots to drill