My one year old baby is starting daycare soon so I bought a 4 door and I need to sell the Talon.
![[Linked Image]](http://membres.dsmquebec.org/DSMData/6.jpg)
The Good:
The car has been in Vancouver since 1999 the year I bought it, never winter driven, always garaged. No rust except tiny bubbles in the front wheelwell lip (1.5inches)
INTAKE/EXHAUST
K&N Filter
K&N breather filter
2G MAF (all honeycombs in)
Extrude Honed intake manifold
2 1/2" downpipe
2 1/2" test pipe
2 1/2" cat-back
Rhino turbo muffler
Ported 2G exhaust manifold
Ported 1G o2 housing
INTERCOOLER/TURBOCHARGER
Buschur Racing Big 16g ported with 10 degree clip
TRE SS braided Teflon oil feed line
RRE Front Mount intercooler
RRE big turbo outlet pipe (J-pipe)
RRE 2 1/2" upper and lower IC pipes
2G ported throttle body elbow
ENGINE/DRIVETRAIN
HKS 264/272 cams
Revised lifters 3rd gen
Stock 7 bolt block / stock head
ACT 2100 pressure plate
Mitsubishi 2G OEM clutch disk
Fidanza lightened aluminium flywheel
ARP headbolts
Mitsubishi headgasket
ELECTRONICS/GAUGES
Greddy PRofec A boost controller
Apexi SuperAFC
TMO stage III chip (8000 rpm cut-off)
TMO datalogger
VDO -30- 0- 30 PSI boost gauge
Cyberdyne A/F monitor
Westach exhaust gas temperature gauge (TRE probe and SS braided probe wire)
Autometer oil pressure gauge
Autometer dual pillar gauge pod
Custom billet aluminium center vent dual gauge pod
SUSPENSION/BRAKES
KYB GR-2 gas shocks
Eibach pro springs
Ractive front strut tower bar
Powerstop front slotted rotors
Hawk HP+ brake pads (à remplacer)
17"X8" Konig Villain
Nitto 450 215-45-ZR17
Energy Suspension Polyurethane A-Arm bushings (à installer)
FUEL/IGNITION
Holley/Walbro 255lph High pressure fuel pump
Greddy/Denso 660cc injectors
8mm Neuspeed wires
NGK BPR7ES spark plugs (.028 gap)
ACCESSORIES
Aluminium/leather short shift knob
Aluminium race pedals
Clifford alarm system
Ignition kill switch
SOUND
Kenwood 4X40watts CD player
S.A.S. Bazooka 8" subwoofer
Orion 200w amplifier
Audiotek crossover
The bad:
There's some bodywork to be done on the car, drivers side door (hinges, paint), quarter panel scratched, roof needs fixing, headliner is unglued, hatch needs to have holes filled where the spoiler used to be. Front brake pads need to be replaced. The engine seems to be knocking, not sure if its the balance shaft/belt or the block. Think of it as needing a rebuild.
This is a great project car at a ridiculous price compared to the price of the parts. Tranny shifts well (BG) except for the usual 1-2 grind, shifts well at high rpms. Estimated 350-375 hp, top speed of 275 (tested against gsx-r 750). The car is nicely setup for a larger turbo.
Asking 4000$
