Just in case anyone's curious:
I made three pulls on Saturday at DPS in Scarborough. My 1st pull was 315 fwhp, 306 ft/lbs torque. But I tossed that dyno run out, my clutch was slipping badly and fuel was messy, leading to a whacked out dyno run.
My next two pulls are below (ran one after another). 288 fwhp, 276 ft/lbs. torque at 12 psi, pump gas. It's obvious I need more fuel (I want to run 18 PSI -- the limit for my block). The stock ECU and VAF are also causing me grief.
Also, the limited slip rocks.
http://photos.lycos.com/s.asp?r=b1a2iskusba13e1n0188nc0tk0_118911 ------------------
Allan
Mazda 626 1994
T3 super 60 turbo
RX7 FM intercooler
V6 2.5L KL03