Does anyone have a wiring diagram for a 97 talon,need to hookup a fcd.

Visit http://www.vfaq.com for the ECU pin-out.

HKS website has the FCD instructions if you need that too:
http://www.hksusa.com/info/download.asp?id=1793#

Thanks Rob

Sorry about that rob should have explained alittle better,need ecu pin out for a 97 n/t talon.

thanks though.

Sorry, Bill, I should have read your sig!
http://www.2gnt.com/index.php?d=1997%20ECU

Rob the fcd that i got said to us pin 1,9and 5 or 13.
the wire colouring is green with goes to the one that says pim on it witch is pin 5 or 13,and the red says +5v witch is pin 1 that says vc on it and the black goes to pin 9 wich says e2 on it is the pin out the right one thanks.

I'm not sure where you're getting that info from, but based on the HKS FCD instructions and the pinout from 2GNT.com, I would wire it like so:

red FCD wire (B) -> 20 Black / White stripe (ECU main power)
black FCD wire (E) -> ground (this could be pin 10, 47 or 50 on the ECU - use the thickest one of these three black wires)

cut 36 Yellow / Black stripe (MAP Sensor signal) and connect:
yellow FCD wire (P) to the end going into the ECU (pin 36)
white FCD wire (P) to the end going into the wire bundle

green FCD wire (I, if present) -> 73 White (Tach signal)

Rob i only have a black,red and green wires on my fcd.