Re: t3/t4 Tubular Header with adaptor plate for td05
[Re: Mark Bondy]
#321355
December 31, 2009 09:38 pm UTC
December 31, 2009 09:38 pm UTC
|
Joined: Dec 2001
Posts: 979
Ottawa
Yasar Issa
OP
Serious Member
|
OP
Serious Member
Joined: Dec 2001
Posts: 979
Ottawa
|
Not sure to be honest, it came with a parts car I got this summer. Some people that came by to see other parts were able to tell from the welds etc, but its a nice solid part with no cracks.
96GST --> Sold
97TSI 13.00@104 <--Sadly SOLD
2003 Mustang New Project
|
|
|
Re: t3/t4 Tubular Header with adaptor plate for td05
[Re: Jasneet Bhogal]
#323162
February 03, 2010 02:07 am UTC
February 03, 2010 02:07 am UTC
|
Joined: Dec 2001
Posts: 979
Ottawa
Yasar Issa
OP
Serious Member
|
OP
Serious Member
Joined: Dec 2001
Posts: 979
Ottawa
|
Well its not iron I can tell you that, not sure if anyone here can chime in and help out. I am sure its some king of strong steel to handle all the heat etc
96GST --> Sold
97TSI 13.00@104 <--Sadly SOLD
2003 Mustang New Project
|
|
|
Re: t3/t4 Tubular Header with adaptor plate for td05
[Re: Yasar Issa]
#323185
February 03, 2010 02:43 pm UTC
February 03, 2010 02:43 pm UTC
|
Joined: May 2003
Posts: 7,263
Niagara Falls, Ontario
Ziggy Dietrich
Senior Member, with Far TOO Much Time on Their Hands
|
Senior Member, with Far TOO Much Time on Their Hands
Joined: May 2003
Posts: 7,263
Niagara Falls, Ontario
|
They are normally made of stainless, but I don't know if that has some kind of coating on it? I would think the coating could be ground away if needed to be for welding.
Mild steel CAN be welded to stainless steel, as long as you use stainless rod or wire. That being said, I would THINK that mild steel could even be welded to mild steel with stainless rod or wire, so you would PROBABLY be safe welding either mild steel or stainless steel to it with stainless rod or wire..
"bluebird" worlds fastest scooter ridden by me
"Whitebird" RIP
|
|
|
|
|
