•2800W Max, Class A/B 4-Channel Car Amplifier
•RMS Power Rating:
◦250 watts x 4 chan. @ 4 ohms
◦350 watts x 4 chan. @ 2 ohms
◦700 watts x 2 chan. @ 4 ohms Bridged
•Max Power Output: 2800 watts @ 2 ohms stereo or 4 ohms bridged
•Full MOSFET Power Supply with Soft Start Class A/B Circuitry
•Preamp Outputs
•Cobalt Blue Illumination (on/off switch for your preference)
◦Circuit Board, Heat Sink, Audiobahn Name Plate, Volt-meter and End Caps illuminate
•Cobalt Blue Digital Volt-meter Display
•Clipping Blue LED Indicators under the volt-meter display
•Cooling Fan
•Chrome Flame Cooling Fan Grill Cover Included (other optional designs available and sold separately)
•Double Sided Glass Epoxy Circuit Board
•High Gloss Chrome Plated Finish
•Nickel Plated Block Terminals
•3-way Protection Circuitry: Thermal, Short Circuit and Overload
•High quality Bipolar Audio Stage
•On/Off Bass Boost Setting: 0 or +18dB
•Variable High-Pass Crossover: 50-750Hz
•Variable Low-Pass Crossover: 50-120Hz
•Variable Subsonic Filter: 20-50Hz
•Signal-to-Noise Ratio: 100dB
•Frequency Response: 10Hz-40kHz
•THD: 0.02%
•4-gauge power and ground leads recommended.
•Dimensions: 11-1/2" L x 12-3/4" W x 2-1/4" H

This is an amazing amp but it is just too big for my new car I am looking for $250

I will consider a trade for a smaller amp that could maybe fit under the seat. No cheap pile crap


This thing is a tank and will take what ever you can throw at it. I paid over $500 for this amp.

I should add i want another 4 channel amp as this is going to run my front and rear speakers. I have a seperate amp for the subs. I may consider moving them both. It is a mono Audiobahn amp. I would have to look it up when i get home.

$220? I want this gone so i can install something smaller

Ive got a Kenwood KAC 7202 4 channel for trade if you like

isnt the 7202 a 2 channel?

Sure is!!!. He might of confused 7402.

Andre double check that for me. It MUST be 4 channel for my application.

My bad. it is a 2 channel. I thought it was a 4 channel for some reason

sold