ALL PARTS have Less than 500km on them unless stated. The car made 400 to the wheels before 2 cyls lost some compression (prob new rings needed and turbo grazed the housing), I've lost the drive to continue with this car altogether.
Head (Resurfaced/refreshed) under 500km ago BC 272 cams 350 BC titanium valve springs and retainers 300 Revised 3g lifters 80 Fidanza cam gears 200 Gates racing timing belt 100 an-10 modded valve cover (mitsubishi lettering) powdercoated Illusion purple Catch can Powdercoated same color with double breather K&n filters on top. (550 as a pair) Coated by Brightside Modded through brightside
Spare unmodded Black powdercoated Evo3 Valve cover 180 ARP headstuds torqued 2 times 80 Felpro permatorque Headgasket Block Bored 20 over line honed and honed with torque plate 4g64 stroker crank 100mm micropolished 250 eagle rods 400 wiseco stroker pistons 400 acl trimetal race bearings coated with ceramic dryfilm lubricant Balance shafts deleted with oem stubby shaft All rotating assembly was balanced and oil clearances checked. Whole Short block id sell for 1700 or in parts. Fuel Wally 255 in tank Rewired for 12v 50 or 75 with rewire Fuel lab inline filter 50 An-6 braided lines from tank to rail and back to return 90 Magnus fuel rail 100 FIC 1050 cc injectors 250 Fuel lab AFPR 150 Turbo/exhaust Hallman Pro boost controller has maybe 50km on it 100 Fp Non Recirc Intake pipe with coupler and filter.80 FP manifold 200 FP Black turbo (need rebuild has some play) lightly brushes compressor housing 350 Pushishment racing recirc 02 with 38mm wastegate flange 250 Tial 38mm Wastegate with 14 lb springs (have 7 lb spring as well to make 21 lb static) 175 Take both for 400 Megan 3inch turbo back exhaust with wideband bung welded in on downpipe 500
Hahn fmic (keeps fogs on 2g eclipses) oldschool but still works 2 1/4 inch lower pipes 2 1/2 inch uppers custom made out of stainless. Tbolts and silicone couplers (black mostly and have a bunch of blue ones too) 350 HKS ssqv flange and bov 90 Or buy with pipes all for 400. Speed density IAT bung welded in. 1g NA throttle body (the one with the neck rather than the elbow and 2 gaskets) 100 Driveline/suspension Prothane mounts on either side black in color with mounts 75 2g awd trans x2 400 tcase x2 100 comp forged clutch fork 60 Act 2100 clutch and full street disc 200 Southbend ss-tz clutch (less than 200km) 400 Exedy chromoly flywheel 150 prop shaft U-joints all replaced and new front yoke 200 Solid carrier bushings 20 New front lower control arms (both sides both arms) 100 per side. Yonaka coil overs (unknown km) 200 Brass shifter bushings Non Cruise throttle cable.40 Braking New rotors and pads all around upgraded outlander front brakes (11.7 inch rotors) 350 ABS Deleted (hardlines ran to prop valve) SS flex lines to calipers 60 Gages AEM wideband (new sensor) 120 Autometer water temp 50 Autometer boost gage 60 Autometer oil press 60 Interior Tan leather Black dash 200 Short throw shifter with base bushings 140 Black Carpet (very clean) 100 Exterior/shell Previous owners took good care of it, has no rust that im aware of, shock towers do look like they were repaired at one point, no rust underneath..... Uncracked window drip moldings (Still nice, black and glossy. 2nd set of drip moldings faded but no cracks that im aware of Black 2gb side strakes (good condition nothing broken) 125 Red 2gb eclipse side skirts 200 Red 2gb eclipse tails 80 Red 2gb Eclipse rear bumper 150 Red 2gb front bumper with butler brake ducts 150 2gb black housing headlights 12- I also Have 2gb talon front/rear stuff too! Cooling Aluminum Rad with dual 10inch slim fans 150 All hoses upgraded to silicone Stant 170F thermostat Misc/electrical JMF Coil pack relocation bracket 50 DsmlinkV3full with 95 EpromECU (chips been soldered in) 600 Blackbox flashable ecu from 98 talon 80 Battery relocation to trunk with taylor battery box and distribution block under hood 250 Vaccuum line distribution block 20 Spare engine harness white Talon twisty side skirts (150) as one fender cap needs repaired. Boxes of misc stuff. Anything not listed is probably available too..
The Shell is also up for sale, its rust free and has been in the dsm community a long time.. and well maintained by each of its owners
Text for fastest reply. 519 572 4064
Re: 98 Tsi Awd Part out.
[Re: Greg Wakelim]
#453467 July 09, 201703:39 am UTCJuly 09, 201703:39 am UTC
DsmlinkV3full with 95 EpromECU (chips been soldered in) SOLD Aluminum Rad with dual 10inch slim fans SOLD Red 2gb Eclipse rear bumper SOLD Red 2gb front bumper with butler brake ducts SOLD prop shaft U-joints all replaced and new front yoke SOLD Solid carrier bushings SOLD FP manifold SOLD FP Black turbo (need rebuild has some play) lightly brushes compressor housing SOLD Fuel lab inline filter SOLD An-6 braided lines from tank to rail and back to return SOLD Magnus fuel rail SOLD FIC 1050 cc injectors SOLD Fuel lab AFPR SOLD Non Cruise throttle cable SOLD ABS delete Pending With Guillume B
Re: 98 Tsi Awd Part out.
[Re: Greg Wakelim]
#453482 July 14, 201702:59 am UTCJuly 14, 201702:59 am UTC
