|
Re: injector impedance???
#171099
October 22, 2002 12:53 pm UTC
October 22, 2002 12:53 pm UTC
|
Joined: Jan 2002
Posts: 198 Toronto
Bali Minhas
Regular Member
|
Regular Member
Joined: Jan 2002
Posts: 198
Toronto
|
Its more like 3-4ohms for low impedence and 13-16 ohms for high impedence.
Turbo is low impedence.
1993 Laser RST AWD 1994 Eagle Talon TSI - 12.0@117.72 (bone stock 172k motor) - RIP
|
|
|
Re: injector impedance???
#171101
October 22, 2002 04:13 pm UTC
October 22, 2002 04:13 pm UTC
|
Joined: Jan 2002
Posts: 198 Toronto
Bali Minhas
Regular Member
|
Regular Member
Joined: Jan 2002
Posts: 198
Toronto
|
Take a multimeter and check the injectors. You will know right away.
You can solder all the wires on the resistor pack, if you want to run high impedence injectors. There is a diagram on DSMTALK somewhere.
1993 Laser RST AWD 1994 Eagle Talon TSI - 12.0@117.72 (bone stock 172k motor) - RIP
|
|
|
Re: injector impedance???
#171103
October 22, 2002 07:25 pm UTC
October 22, 2002 07:25 pm UTC
|
Joined: Jan 2002
Posts: 198 Toronto
Bali Minhas
Regular Member
|
Regular Member
Joined: Jan 2002
Posts: 198
Toronto
|
Ya those would be high impedence.
If you want to use them, just search DSMTALK. There was a diagram I once found for using high impedence RX-7 550CC Turbo injectors (89 up) with our Talons. It involved taking the resistor pack, cutting the wires and soldering them all together.
Try a search, it will save you from forking out $290 USD for RC's like I did.
1993 Laser RST AWD 1994 Eagle Talon TSI - 12.0@117.72 (bone stock 172k motor) - RIP
|
|
|
|
|
|