Electric Fuel Pressure Sender Question
#175483
May 11, 2005 04:31 pm UTC
May 11, 2005 04:31 pm UTC
|
Joined: Aug 2000
Posts: 780 Markham, Ontario, Canada
Mark Magnoli
OP
Serious Member
|
OP
Serious Member
Joined: Aug 2000
Posts: 780
Markham, Ontario, Canada
|
Hey Guys, I just got a deal on some 52mm Defi Link Gauges - EGT, Fuel Pressure and Boost. Now, my question is regarding the fuel pressure gauge and installing the sender. The sender is a typical 1/8 PT fitting. It states on the Defi site Deif Install Site that you need to install this on the fuel feed line (high pressure). I don't really want to cut this line and tap into it. I was thinking of installing "some kind of fitting" on the line out of the fuel filter that can accommodate the 1/8 PT fitting. So basically go from the fuel filter to this "fitting" that the sensor taps into, then install the fuel feed line with stock banjo bolt. Anyone know if this can be done and if such a "fitting" exists? I came accross this: B&M fitting Is this what I'm looking for??? Thanks Mark
Mark '97 Eclipse Spyder GSX - (12.7 @ 110 w/1.8 60') '11 335xi Coupe '14 X3 MSport
|
|
|
Re: Electric Fuel Pressure Sender Question
#175485
May 11, 2005 04:52 pm UTC
May 11, 2005 04:52 pm UTC
|
Joined: Aug 2000
Posts: 780 Markham, Ontario, Canada
Mark Magnoli
OP
Serious Member
|
OP
Serious Member
Joined: Aug 2000
Posts: 780
Markham, Ontario, Canada
|
Rob, should I be emailing you directly my questions You seem to answer every question I have ....lol I take I need to order B&M part# 46062? Mark
Mark '97 Eclipse Spyder GSX - (12.7 @ 110 w/1.8 60') '11 335xi Coupe '14 X3 MSport
|
|
|
|
|