Forums Calendar Active Threads Forum Help
Previous Thread
Next Thread
Print Thread
Rate Thread
The Adhesive and the Gasket .....+ Port and Polishing ? #204215
August 19, 2002 03:24 pm UTC August 19, 2002 03:24 pm UTC
Joined: Mar 2002
Posts: 896
Toronto,Ontario
Rafal Kuleta Offline OP
Serious Member
Rafal Kuleta  Offline OP
Serious Member
Joined: Mar 2002
Posts: 896
Toronto,Ontario
1. What kind of adhesive would/could/should i use on the Throttle Body Gasket to hold it in place ?

2. ...Did anyone here do a whole intake job ? (k&n, Thrrottle body boring, aftermarket intake manifold,and port and polishing job on the cylinder heads) Any suggestions ...concerns etc about that ?

3. What would be the benefits of this if a turbo was installed later on ?
Re: The Adhesive and the Gasket .....+ Port and Polishing ? #204216
August 23, 2002 04:35 am UTC August 23, 2002 04:35 am UTC
Joined: Dec 2001
Posts: 600
Toronto, ON
Shawn Petrie Offline
Member
Shawn Petrie  Offline
Member
Joined: Dec 2001
Posts: 600
Toronto, ON
pick up some RTV silicone from your local CT. you should only need a thin bead (if any) around the TB

92 TSi AWD
Fast!!!
02 Honda RC51 1000R
FASTER!!!

Moderated by  Jeff Mitchell, Rob Strelecki, Ryan Laliberte, Sean Dean, Steve Kinnaird 
Forum Rules · Mark All Read Contact Us ·
Powered by UBB.threads™ PHP Forum Software 7.6.1.1