Any of you guys know what the actual flow is on a set of
Delphi / FIC 1000cc injectors?

I'be been trying to look it up on the web but have come up empty handed. I heard a while back it's either 940 or 950cc but I'm not sure.

Thanks

It depends on what pressure it's rated at. 1000cc injectors flow 1000cc/min at a certain pressure. If you have an AFPR, flow rates are nothing more then a comparison against another injector. You just have to make sure both injectors are tested at the same fuel pressure. Do you think you are running out of injector?

No not at all Tim. I'm trying to do a bit of home work before ordering my DSM Link. If I can figure out the proper flow, I can adjust the global and deadtime accordingly and hopefully not be too far off for tuning purposes.

In the dsmlink manual as a starting point it lists the FIC 950.

Global is -53% and the Deadtime is 315, so you can probably drop the global slightly from there and more than likely leave the deadtime about the same to start off anyway.

And I think for a 2g your base fuel pressure should be about 43-44psi something like that.