Starter plate inquiry - Club DSM Canada

Register Log In Forums Drivetrain Performance, Mods & Repairs Starter plate inquiry

Print Thread

Rate Thread

Starter plate inquiry #314084 September 20, 2009 02:03 pm UTC September 20, 2009 02:03 pm UTC
Joined: Jun 2002 Posts: 502 scarborough Francis kofi OP Serious Member
Francis kofi OP Serious Member Joined: Jun 2002 Posts: 502 scarborough	Hello guys. I needed to install my temporary transmission in a hurry so that I could move the car to it's present location. The starter plate was damage so I had to install the transmission without it, the problem now is that the starter is sitting a millimiter or two too close to the flywheel thus making noise at start up. Is there anything I can do short of pulling it back out again to install a new starter plate which I still have to locate? Hoping that nothing breaks this summer.

Re: Starter plate inquiry [Re: Francis kofi] #314103 September 20, 2009 05:45 pm UTC September 20, 2009 05:45 pm UTC
Joined: Apr 2002 Posts: 15,322 Loc: Loc: Rob Strelecki morum foderator
Rob Strelecki morum foderator Senior Member, with Far TOO Much Time on Their Hands Joined: Apr 2002 Posts: 15,322 Loc: Loc:	I would try using washers as shims between the starter and the bellhousing. 1993 Eagle Talon TSi FWD 13.8 @ 106 :::: 14.1 @ 117

Moderated by Chris Mckee, Ghislain Goudreau, Rob Strelecki, Ryan Laliberte, Steve Kinnaird, Tim Hunt

Hop To

Powered by UBB.threads™ PHP Forum Software 7.6.1.1