Where can i get a Turbo crush washer for a fitting locally anyone have any idea?

NPT does not require a crush washer. It is a tapered thread, and seals on the taper. Crush washers are needed with straight threads.

Its that cooper crash washer that i got off you for the holset fitting

Most parts stores should have an assortment of copper crush washers in stock. Take your fitting along (or measure its diameter) and they should be able to match it up, no problem.

Called Jrp, performance improvements, canadian tire, part source and so far nothing.

Try princess auto for a kit of them, or even the hardware stores you might just need to browse the aisles since they really won't know car stuff.

A hydraulic shop might have what you need, try CISCO, Dixie N. of 401.

Hi Ruben.

You can try these guys. I used them when I was at my old company.
Imprial Brass Fittings

You can also try these guys.
Try Hard

Good luck.

That's weird... when I was in a pinch I got some from CarQuest. I know the Guelph NAPA carries them. We have an absolute ton in stock (I work for a jobber). In fact, probably the only jobbers in town that don't carry them are PartSource/CT and PI..

Pretty much anyone who sells brake parts will have them, used on many calipers.

CT, Parts Source, NAPA, Princess Auto..they all have crush washers at every location. Don't see how this is such a hard item to find...

In fact - Parts Source has quite a good selection of them, usually and has copper, aluminum, rubber, rubber&aluminum ones, etc.

What size is the fitting?

Had to go to ziggy and ended up picking them up there thanks guys!