So here's my issue. Haven't done much with the car all summer as I injured my knee. It was running in the spring but had fuel leak and needed other things finished. Now that I'm mostly healed I've been back working on the car. Got my fuel leak figured out and fixed. Also put in my bigger injectors. Set the global fuel in Link and tried starting the car and it won't run or even attempt to fire just cranks over. Looked at a live stream in Link and noticed that tps is pegged at 100%. So figured tps is probably no good and ordered a new one. Put it in and pulled a new stream on link and still stuck at 100%. Not sure what I've done or what's wrong. Need some help to figure it out.

Thanks guys

Can you post a log? Does the tps still read 100% if you unplug the sensor?

Yeah and if you start a log and move the tps does the raw value change at all?

Sorry been a busy couple days. I unplugged the tps sensor and it was still reading 100%. With it plugged in and moving the throttle there is no change in the raw value.

You may have wiring issues there. What voltage is link showing for tps volts?

Or a Link offset setting incorrect.