Hello,

Well I changed my timing belt, and bshaft belt and all the seals this weekend since my belts were covered in oil from a bad seal, lots of fun!!

I put it all back together and started her up. It ran fine, idles well.
I took it out and put gas in it and now when I accelerate it really bogs out, and I dont get much pull anymore. The engine sounds fine, I made sure all timing marks were aligned.

I logged it and get knock of 0 at 6000 rpm but no power. Timing logs at 22 degrees at 100% wot well 99.6 % which mine maxes out at. Boost is 15 psi on my gauge. FTRL IS 129.6, FTRM IS 121.0, FTRH IS 123.4. INJD IS 67.9%, O2 = 0.95V MAFS = 943.4 hz.

I get a couple of flags on the logger
FLG0 F-
FLG1 C- not sure what these mean.

All help is greatly appreciated!
Thanks