Got a call from the shop and he has a problem and I need some help.
I brought in 2 heads one was messed from the guide removal(oops)
The other was an additional spare I had.
He measured the spots where the cams sit, and he said that they are off quite a bit(I forget the measurement). And when he puts a straight edge on it, you can actually rock it back and forth.(This happens with both heads)

He is wondering if when you torque the head down, the cam spots will even out?
He said he has a e-mail into some other places, and wants me to check into it aswell.

Anyone else run into this problem?

Stock.