I sealed up and installed the lights this evening.




Powered up! High and low beams look great. I'll get some cutoff pictures once the car is off the jackstands. I have the front hubs off the car to install 1/2" 20 tpi wheelstuds to match the ones on my rear axle...



This happened after about 30 seconds of the lights being on. Its all fogged up around the beam, but they obviously haven't been exposed to any moisture as of yet, and I'm entirely sure the housings are quite well sealed....

Could it be that I had the lights in the oven not long before heading outside, and its not too far above freezing now? Would having put the bulb in inside the house where its warm make it fog up outside where its cooler and gets exposed to the warmth of the projector? Any ideas?