So last night I decided I would spend some time taking out the condenser. So I started by taking off all the lines that run from the condenser to the compressor on the drivers side, relatively easy task. I then decided to take out the condenser itself, at first my thought was that I was going to push back the rad and then muscle out the condenser, definitely not enough space with the stock fans, so I had to disconnect the rad and then pull it out and then take the condenser out. After getting it all out I took a look at the rad and it was not in the greatest condition, when i touched any of the lower fins they just crumbled off of the rad. Going to pick up an aluminum rad with some slim fans in the next little while.