Been a while since an update; bout a month. Progress is slow because I'm working out of town and only home on the weekends. I don't always have time on the weekend to do anything with the boards. I did manage to get a few more boards drilled this weekend though.

Printing the designs to the PNP Blue.


Ready to be transferred to the copper clad.


Toner transferred and ready to be drilled.



All the boards drilled so far. This is all very time consuming but on the upside I haven't broken 1 of the drill bits yet.


I spent a LOT of time hunched over the drill press. The Dremel work station is a very nice piece for the price though.


The thin board I bought is really nice, I can easily cut it with a pair of scissors so getting it to conform to the curves of the tails shouldn't be a problem.
Here's the headlight turn signal board cut out.


Test fitted into the headlight.


That's it for now. Not sure when I'll get more work done on them.