Finished soldering up my brake light boards. I can now temporarily mount them and draft up the 5th and final board for the tail lights.


Here's a back of the boards.


Here's a comparison to the previous version of the boards, you can see there are a lot more LEDs in the new version.



I also started working on the dome lights again, I want to run a voltage regulator to save my LEDs.
First was installing some glazing points to mount the boards too (ala azdave).


Couple seconds with my MAP torch to heat these bad boys up and then push them into the plastic.




I picked up some of the dummy bulbs off of eBay to plug into the factory bulb holder so it will be plug and play.


I still need to dye/paint the dome light housing seen in the pictures.
I also brought the center section boards back to the drawing board once again! I messed them up and had the LEDs facing the wrong way so they wouldn't light. Of course I noticed this AFTER I transferred and etched the boards, sigh.
I've also finally posted about the MSP430/TLC5940NT combo sequencer over on 43oh!