Ok, here is my new gremlin! Car seems to deal with one only to inherit a few more.
Was having issue with no fuel pump even with Link V3 box checked and simply wired straight from Fuel/mpi relay blk/blue wire and voila! Now I have fuel but NO SPARK!
Have coil on plug set up wired this way.
http://www.dsmtuners.com/forums/articles-electrical-wiring/290665-coil-plug-wiring-install-pics.htmlI also wired my transistor like this.
Stock (2g) 8 pin connector wire colors:
pin 1: blue-black (output to fire cyl 2,3 coil's primary)
pin 2: brown-red (input from ECU to fire cyl 2,3)
pin 3: black (ground)
pin 4: white (tach output to ECU and gauge)
pin 5: unused
pin 6: larger black-white (+12V from ignition switch)
pin 7: black-blue (input from ECU to fire cyl 1,4)
pin 8: black-white (output to fire cyl 1,4 coil's primary but leaves coil as blue-red going to single pin "engine speed detection connector", then from there to pin 8 here as black-white)
Why am I getting no spark with plug tester??
When I turn the cas by hand I know that would usually kick on fuel pump and create spark but now it doesn't do anything.
ECU directly pin 88, 89 to cas white and yellow wire.
Ground I soldered to ECU sensor ground out and 12+ to the Fuel pump mpi relay red wire.
Ok community!! Hit me with suggestions!!
