I am only reusing flywheel bolts and pp bolts.

The full list of replaced items:

ACT STREETLITE FLYWHEEL (MACHINED)
SOUTHBEND STAGE 2 CLUTCH & PP
MD719925 BEARING, CLUTCH RELEASE
MD719602 FULCRUM, CLUTCH RELEASE FORK
MD706185 CLIP CLUTCH RELEASE BEARING RETURN
MD737767 FORK, CLUTCH RELEASE
MD718077 BOOT, CLUTCH RELEASE FORK
MD132656 FLANGE, BOLT 10x80
MR187766 CONED DISK, 10.5
MD128901 GASKET,T/C EXHAUST GAS INLET HOLE
MD183243 REAR MAIN GASKET 6 BOLT
MD343564 REAR MAIN SEAL

I'm most happy with my temporary front lower support.

Though I have decided, this is a long term car so I will try and hunt down the whole front assembly and get it done properly.

On a side note, was trying that [url=http://www.evapo-rust.com/]EvapoRust[/ulr] on some pieces. MINT but $$$$. Gonna go try the 5$ 4 litre apple cider vinegar instead.
Gasket should be in tomorrow, so I need to finish cleaning around the tranny area in engine bay and start de-rusting some bolts.

98,6Bolt,3"EXH,LINKV3,780cc,SD,SCM61@26PSI, 340LPH,AFPR,TSBOV,REARWB,FMIC,2"RAD(20/80/WW)