For the record, new pivot ball has diameter or .501" The old one (it was shimmed) was around .485" (in case anyone wants to reuse a pivot ball :P)

Getting ready. Rear seal in tomorrow (today as it is 1am)

This looks worse under a flash. It's clean enough.



Front Subframe.


Front nearly ready to button up.


Hign pressure, High Temp, Synthetic Grease. And now I know why the call it the jesus clip. Once on, you pray it holds. Not much holding it and makes me uneasy. Moves nicely though. I will clean up excess grease on the spline tomorrow.


Majority of Gasket is off. Again.. looks worse with flash >.< I am fearful of crap falling into the oil pan with huge those gaps.


Centermember Bed Armored.


Tomorrow.. it begins...