Checked fluid level. Ok.
No Leaks.
Bled System.

I was under the dash checking out wiring, and tried to push on the pedal. Measuring at the tip of the pedal, there is 1/2" to 3/4" play before it even starts pushing the rod. (hole for pin must be slotted from use) Then another 1.25 inches before the rod starts to feel resistance.

I am at the end of the adjustment rod.

Guess a new pedal assembly is in order >.< The master still looks new (supposedly was replaced last year)

Or would it be possible to weld up the hole, then re-drill the hole for the pin?