Originally Posted by Alex Akachinskiy
Originally Posted by Manny Sandhu
Not sure if its been suggested but how about drilling a hole tapping it and putting a bolt in, then leverage off that?

Apologize if its been suggested already too lazy to go back and read lol


wink

Originally Posted by Salomon Ponte
Originally Posted by Jason Drew
It takes all of 5 minutes to remove the drivers side axle, the half shaft makes it very easy, it doesn't even have a clip holding it in the trans. Also, have fun drilling or tapping that hardened axle.

Get some shavings or bits of a broken drill bit or tap in the trans and you've got a LOT bigger job on your hands.


Exactly this, and don't forget the stub will likely spin in the tranny. It's exponentially more work to do what you're proposing, Mike, than to just pop the driver side out and go.
Originally Posted by Jay Stacey
Me and Jamie tried sticking sh!t thru an old diff he had laying around... And I think its gonna be harder then you think. We couldnt even get a thin screwdriver past the center..


wink

'99 GSX GT35R
'03 CBR 600RR