Picked up an aluminum radiator for a MK3 GTI. I had to do some minor mods to the core support so it would slip under. Right now the stock hood latch is still there but to get both 12" fans installed it's got to go. I'll run some Aerocatch hood pins to latch the hood down.
This freed up a ton of room in the engine bay.


Fender harnesses installed, still need to route/secure some things under the frame rails but I didn't bring my jack out.



Seam sealer on all the block off plates.


Vacuum lines run to the BOV and IAC (can't see it because it's behind the motor.


Master cylinder installed. Running a Wilwood adjustable push rod that I still need to fine tune the adjustment of.


Started running the brake lines, 4 ports will make it a lot easier.