The hot side housing is stripped. I needed longer bolts so I can put a nut on and am using 10.9 bolts from Ottawa Fastener and Supply. I just tried the bolts themselves last time as it bit into the messed up threads. Didn't hold. Now using nuts that are ground to hug the curve on the hot side housing.

Using the Mitsu washers on all of them. This setup is holding fine for now. Still undecided on Holset vs FP Red vs Rebuild PT6162 (Flows roughly 64lbs. I'm only hitting 43).


Last edited by Charles Lavoie; September 29, 2016 08:46 pm UTC.
98,6Bolt,3"EXH,LINKV3,780cc,SD,SCM61@26PSI, 340LPH,AFPR,TSBOV,REARWB,FMIC,2"RAD(20/80/WW)