Hey,

Does anyone know if there are any differences between the settings in DSMLink for High Z vs Low Z injectors? I installed a new set of FIC High Z 650s in my 2g and for some reason the base settings on the DSMLink site seem way off.They indicate a starting point of -31% and a 210 deadtime. If I use these settings the car barely idles, and when it does my wideband reads 17.8-18.1. The only way I can get the car to idle near 14.7 is if I either crank the deadtime way up, or increase my globel from -31% to around -25%.

Anyone have any ideas why this is? Its likely not an issue, just curious is all.