At first I used a plate for the troubleshoting of an eratic idle. (I suspected the EGR to be the cause) I also cleaned the trottle body and the intake manifold. The intake manifold was pretty dirty. I kept the valve off in an attempt to keep it clean as long as I could by preventing exhaust gases to enter the intake.

Performance stand point it made just a little bit more power. Probably because the intake manifold would not get as hot from the warm gas.

I did not see any change on the Air/Fuel gauge.

It is pretty easy to install once you snaked your arm bellow the trottle body. Even easyer if it's off (TB)for cleaning.


I'd do it again...

TX Paul.

Ghislain.

[This message has been edited by Ghislain (edited March 27, 2000).]